Sandplast LW

logo

Выберите вариант

Варианты

3 - 4 working days
Hand trowel for rooms that are exposed to changing moisture with good filling ability. Finished with wall cladding or suitable ceiling or wall paint.
Sandplast LW is a ready-mixed filler ready for use. Used for leveling ceilings and walls, has optimized working properties and filling capacity, good sanding properties and minimal shrinkage.
  • Moisture stable hand trowel
  • High breaking strength
  • Blue tone

Территория

Опасные слова

No

Риск и т.д.

(EUH208) Contains sensitizing substance. May produce an allergic reaction.

Информация

Product Data Sheet 1 Product Data Sheet 2 Technical Data Sheet 1 Technical Data Sheet 2 Safety Data Sheet DOP

Время сушки

Dust dry at 20 ° C, 60% RH: 2 hours Dry treatment at 20 ° C, 60% RH: 20 hours Cured through at 20 ° C, 60% RH: 28 days

Поверхность

Wall Ceiling

Заканчивать

...

Достигать

1 m² / liter depending on substrate and application method

Характеристики

Moisture stable hand trowel High breaking strength Blue tone

Описание продукта

logo

Product description

  • Hand trowel for rooms that are exposed to changing moisture.
  • Contains light fine-grained fillers with good filling ability.
  • Finished with wall cladding and / or suitable ceiling or wall paint in the desired color and gloss.

Special features

  • Moisture stable hand trowel
  • High breaking strength
  • Blue tone

Environmental information

Remove as much putty as possible from tools before washing in water. Do not pour residual liquid putty into drains, drop it off at the local recycling station. Minimize your paint waste by calculating in advance how much to use. Store excess paint correctly so that residues can be used, thus minimizing environmental impact.

Применение

logo

Application

  • Filling and reinforcing joints with Marco Spark - perf or Sheetrock plaster tape and filling screw holes on cardboard-covered plasterboard.
  • Stain and full filling by leveling plaster, concrete, lightweight concrete, cardboard-clad plasterboard and previously painted surfaces.

Treatment

  • Loose material and paint are removed by cleaning, sanding and dusting.
  • Dirt, dirt, grease and contaminants are removed with Fluren 37.
  • Water-soluble discoloration, nicotine and soot are cleaned with Fluren 49.
  • Hard, smooth surfaces are sanded.
  • The filler is applied and leveled.
  • Plasterboard joints are dusted and filled and gypsum tape is turned with the prefabricated fold towards the joint, pressed firmly with the filler and pressed down into the wet filler.
  • The filler tape is pressed in so far that a thin layer of filler mass is deposited on the outside of the filler tape.
  • In the same operation, scrape over the filler tape.
  • After drying, fill joints and screw holes twice.
  • The surface is sanded and primed or primed before further treatment.

NOTE

  • The gypsum boards must be set up in accordance with the manufacturers' instructions and standards.
  • See Flügger work instructions for gypsum board, grouting joints.

Технические данные

logo